stdd (short for "simple time display daemon") is a handy little daemon for the Raspberry PI device that can be used to display the current time.

113 Commity

1 Vetvy

8 Vydania

Helmut Pozimski e86a1c2d7b reformat README to Markdown and move it to README.md		7 rokov pred
adafruit_7segment	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
config	fa02a58907 add json config file	8 rokov pred
debian	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
default	3318a15559 further improved the debian package build scripts	10 rokov pred
doc	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
stddlib	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
.bzrignore	05e8135317 updated TODO	11 rokov pred
Changelog	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
INSTALL	96a12c31d9 updated README and INSTALL	10 rokov pred
LICENSE	8834fb146d added minimal debian build scripts	10 rokov pred
MANIFEST.in	3318a15559 further improved the debian package build scripts	10 rokov pred
README.md	e86a1c2d7b reformat README to Markdown and move it to README.md	7 rokov pred
setup.py	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred
stdd	8e377343be refactoring to conform to PEP8 and picking up some suggestions from pylint	8 rokov pred

About

stdd (short for "simple time display daemon") is a handy little daemon for the Raspberry PI device that can be used to display the current time on a 7 segment display with a HT16K33 backpack from Adafruit Industries. It makes heavy use of the python libraries published by Adafruit to control the display via I2C.

USAGE

see ./stdd

Dependencies

stov depends on the following software to be installed:

* python 2.7 or higher (lower 2.x versions might work but are not tested 3.x is not supported)
* python-smbus
* python-pcrtl (optional)

COPYING

see LICENSE

Configuration

   hw_address:    hardware  address  for  your  display, a common value is
   "0x70" use i2cdetect to find yours if it doesn't match

   blink_colon:   define if you want the middle colon to blink, 0 = off, 1
   = on

   brightness_high:    value  used for "high" brightness, valid values are
   0-15

   brightness_low:     value used for "low" brightness, valid  values  are
   0-15

   set_brightness_low: time of the day to change the brightness  from
   high to low

   set_brightness_high:     time of the day to change the brightness  from
   low to high

   syslog_level:  maximum  syslog  level to log, stdd uses debug, info and
   error

   syslog_facility:    syslog facility to use for logging (default:  user,
   can also be daemon)

Known issues

None yet

Installation

see INSTALL

README.md